Introduction
We built this overheat-protection halogen heater to be the heat source that actually fits your industrial gear. No fuss. Just a direct-fit solution that throws serious, focused heat exactly where you need it—especially when space is tight and you can’t afford temperature swings.
Power and Size, Without the Fluff
This thing runs at 400V and 2500W, packing a lot of heat into a 300mm tube. It’s the kind of power that gets a small zone hot fast, but it does need a strong electrical setup and a cooling system that’s up to the job. The 300mm length is the sweet spot for cramped spots. And with 2500W on tap, you hit your target temperature quickly, even when the load keeps changing.
What It’s Built With—and Why It Matters
The quartz tube is halogen-filled and coated to keep the filament temperature in check and stretch the heater’s life. And there’s built-in overheat protection that cuts power if the tube runs too hot, so the parts around it stay safe. The R7s connector is a clean, two-pin design. It wires up straight and locks in solid, so the install is secure and repeatable—without needing extra mounting hardware.
Where It Shines
This setup is a natural fit for PET blowing, plastic forming, and other processes that need fast, focused heat. The halogen design warms up quickly and holds steady output, and the R7s termination means replacement is a simple drop-in. Just one heads-up: it does put thermal load on the surroundings. So make sure your machine’s cooling and thermal shielding are ready for it.